Zubehörteile

Zubehörteile

 

EC - Elektrische Wurfelstecker

The EC connectors, according to EN 175301-803, are in the model “A” configuration and are used mainly for the electrical connection of valve solenoids.

When they are correctly installed and coupled they provide waterproof protection according to IEC EN 60529 standards, class of protection IP65.

The class of insulation is therefore in compliance with IEC 60664-1:2007specifications, operating voltage up to 250 Volt.

The wire terminal block is removable from the external housing to allow the wire connections to the clamps, and to allow the electrical contacts can be turned through 90° (except version H) if required.

Four different types with specific functions are available:

  • type A, connector two poles + ground
  • type B*, with LED
  • (available voltages: 10 ÷ 50 and 70 ÷ 250V)
  • type D, with bridge rectifier
  • type H, with RC damping circuit

Type A is also available in gray colour, to differentiate the solenoids mounted on the side “A” or “B”.

They are supplied with M3 fixing screw and NBR gasket.

 
49000 | | | 3D
 

ECL - Schaltverstarker mit niedrigem Leistungsbedarf fur on-off Ventile

The ECL connector is a digital amplifier controlling open loop on-off valves directly from PLC.

The unit supplies a set current independently from temperature variations or load impedence.

Setting is possible by buttons and display inside the case, or with a PC by RS232 with the software EDC-PC/10.

 
49300 | | | 3D
 

ECF - Verstarker fur Schnell-Umschaltung von-off Ventile mit einer Spule

The ECF connector is a digital amplifier controlling open loop on-off valves.

The unit supplies a set current independently from temperature variations or load impedance.

A quick solenoid energizing is possible in two different ways, according to the used coil type (12V o 24V).

Setting is possible by buttons and display inside the case, or with a PC by RS232 with the software EDC-PC.

 
49310 | | | 3D