Позиционирование осей

Позиционирование осей

 

EWM-S-AA - Аналоговая карта управления позиционированием в следящих системах, с аналоговым сигналом по обратнои связи

The EWM-S-AA card is designed for positioning drive applications. It allows easy stroke positioning control of hydraulic actuators in closed loop systems. 

Velocity can be defined also by an external speed command.

Card setup via software only, through an on-board USB-B port.

The output value, voltage or current type, is configurable via software.

CLICK HERE to download the start-up manual.

 

NOTE: to download the PDF catalogue of the old series click here 

 
89410 | |
 

EWM-ST-AA - Analogue positioning card with analogue feedback and digital setup, for stroke control in closed loop system

This card is designed for steam turbine application. It allows easy stroke positioning control of hydraulic actuators in closed loop systems.

  • Card setup via software only, through an on-board USB-B port.
  • The card has a monitor output to DCS.
  • It’s available with integral power amplifier or current output.

CLICK HERE to download the start-up manual.

 
89411 | |
 

EWM-S-AD - Аналоговая карта управления позиционированием в следящих системах с цифровой обратной связью

This card is designed for closed loop positioning of hydraulics actuators where an high accuracy is needed by means of a digital SSI sensor.

The card controls a directional proportional valve with integrated electronics and allows an optimal use of overlapped and zero-overlapped proportional valves.

The card has a monitor output to DCS.

An additional input for analogue sensors is available.

The output value, voltage or current type, has to be configured via software.

Card setup via software only, through an USB-B port.

CLICK HERE to download the start-up manual.

 

NOTE: to download the PDF catalogue of the old series click here 

 
89420 | |
 

EWM-SP-DAD - Карта управления осями (положение и давление) с интерфейсом сообщения Profibus

This card has been developed for positioning control with integrated closed loop pressure where an high accuracy is needed, using a digital sensor for positioning, and analogue sensors for pressure sensing.

The card is an axis controller with two positioning control mode, SDD and NC. It communicates with the PLC via the integrated Profibus interface.

An integrated control for pressure limitation for one or two sensors (differential pressure), completes the card.

The output value, voltage or current type, has to be configured via software.

Card setup is via software only, through an USB-B port.

CLICK HERE to download the start-up manual.

 

NOTE: to download the PDF catalogue of the old series click here 

 
89440 | |